Flush Settings

Below is a video and images of a ring I made to practice flush settings with.

Part of the mandatory course work is to do 5 flush settings. I managed to put my 5 attempts into one band. We were given some thick, silver wire to practice with which is what I have used above. I bought some hand stamps a while back and decided to have a little fun and decorate the band with a star embellishment and then set the stones in-between them.

I have used 3 black, 2mm C.Z’s and 2 yellow, 2.5mm C.Z’s for this band.

 

  • I stamped the stars into the metal then created the ring shank.
  • For the 2mm stones, I first drilled through the band with a 1mm drill bit. I found I was having trouble taking the 2mm burr far enough through the metal which ended up being because I needed to go through the band with a slightly larger drill after the first.
  • So I then used a 1.5mm drill bit through the 1mm hole previously drilled and then the 2mm burr had no problems cutting through the metal. (I also applied some oil before burring into the metal).
  • I burred into the band slowly, stopping often to check if the stones girdle (table) was flush/in line with the metal (almost disappearing into the metal). I don’t want the stone sitting above the metal as it cannot be set and if it’s too low it won’t work properly either.
  • Once I’d burred to the correct depth, I placed the stone in the space and gently using my burnishing tool, pushed round the stone. This should press the metal over the stone to secure it in place.flush2

I used the same method with the 2.5mm stones. However, for the drill bit, I used a 2mm drill and then a 2.5mm burr. My lecturer also showed me how to create a ledge to have the stone ‘pop’ into it using a heart burr but I was not brave enough to attempt it. I may give it a go next time though!

Below is the burnishing tool I made to help set the stones using an old drill bit and handle.


RECAP ON HOW TO FLUSH SET STONES

~ 2mm Stone (C.Z)
~ 1mm Drill bit
~ 1.5mm Drill bit
~ 2mm Burr

~ 2.5mm Stone (C.Z)
~ 1.5mm Drill bit
~ 2mm Drill bit
~ 3mm Burr

~ Place stone into the snug fitting which should be sitting with the girdle (table) of the stone almost disappearing under the metal.
~ Use burnishing tool to push the metal round the stone to secure it in place.
~ A Vernier Gauge can also be used to measure the stones and drill bits before use as on occasion, sizes can vary slightly from what they are supposed to be which can affect this setting method.

Stevie

Advertisements